Xrotor VTX (Video transmitter) for FPV Racing


This product is currently out of stock or preorder status
Xrotor VTX (Video transmitter) for FPV Racing
MAP $32.49 | MSRP $44

Video Transmitter for FPV mini Quad

  • Plug in installation: less wires = more reliabilities, more time on air.
  • Stack on top of each other: HOBBYWING 4in1 ESC + Flight Controller + VTXFPV Regulatory Notice

FPV Regulatory Notice: The use and operation of this type of product in the USA and many other countries may require a license. In the USA, you will need a "HAM" amateur radio license. Learn more about HAM licenses. It is your responsibility to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. Hobbywing cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.  By purchasing this product you are agreeing that you have read this notice. 

The unit by default is in compliance with relevant CE & FCC regulations.

  • Different nations have different regulations over the radio frequencies & transmitting power, and also requires that users of radio equipment must own relevant licenses including but not limited to HAM license, any license and a permit required by national law and a local regulation(s). By purchasing HOBBYWING product, you agree that you are familiar with the local regulations before using this product.

  • Unlocking the device, you agree to follow local rules with required licenses. You are solely responsible and liable for any problems resulting from the use.
Model 5.8GHz Video Transmitter
Frequency  5.3GHz-5.9GHz
Power 0 / 25mW / 200mW / 600mW
Current 70mA / 100mA / 250mA / 350mA @ 12V
VTX port
SMA Female Connector
Antenna port SMA Male Connector
Supply Voltage 7-25V
size 36x36mm
Pitch-row 30.5x30.5mm.
Unlocking the device

Press the “Power Adjustment Button” and the “Frequency Adjustment Button” (at the same time) for 5 seconds to enter the “unlocking” mode. After entering the mode, press the “Power Adjustment Button” to change the unlocking or locking status. Press “Power Adjustment Button” and the “Frequency Adjustment Button” for 5 seconds again to save the setting and exit the mode. After entering the unlocking mode, the LED segment display on the VTX will display the current status; “L” indicates “Lock” and “U” indicates “Unlock”. 


More information, please refer to the user's manual 

  • READ User's Manual under "warning section".
  • HOBBYWING products purchased from Hong Kong/Chinese retailers do not conform CE/North America regulation, products purchased from Hong Kong/Chinese retailers will be considered non-warranty.
  • Discount /auction stores such as eBay, etc are considered "non-authorized store" in North America. Products deem non-warranty.
Combo available
Best match with